WeChat
E-mail
What requirements should Jiangmen foreign trade iron barrel follow?
What requirements should be followed in the production of tin barrel
The production of tin barrel should follow certain standards, so as to produce products with high reliability and consistency. The barrel body, top and bottom of the product are made of the whole sheet steel, which is not allowed to be spliced, and the barrel body weld is resistance welding. The barrel body type of tin barrel shall comply with the following regulations:
There are two ring bars, and there are 3 to 7 corrugations between the ring bar and the top of the barrel and between the ring bar and the bottom of the barrel. The barrel body, top and bottom of the tin barrel shall be filled with sealing filler according to the requirements. The type of double or triple curling can be selected. The closure device shall be set on the top of the barrel according to the opening type.
If you want the tin bucket to be used well, you can't do without grinding
Rough grinding method, using 600 ? abrasive belt to grind the workpiece on three sides. The goal of this process is to remove the solder joints left by the workpiece welding, and the bumps presented in the previous process, and reach the initial formation of the weld fillet. The horizontal and vertical planes are basically free of large scratches and bumps. After this process, the surface roughness of the workpiece should reach r0.8mm. Attention should be paid to the inclination of the abrasive belt machine and the pressure of the abrasive belt machine on the workpiece. Generally speaking, to be thrown into a straight line with the surface is more moderate!
Semi finish grinding, grinding the three sides of the workpiece with 800 ? abrasive belt according to the previous method of reciprocating grinding, mainly correcting the joints presented in the previous process and further fine grinding the marks after rough grinding. The marks left by the previous process should be repeatedly ground until there is no scratch on the surface of the workpiece and it is basically bright. The surface roughness of this process should reach r0.4mm. (note that no new scratch or bruise is allowed in this process, because such defects cannot be repaired in later processes.)
Article source: Jiangmen foreign trade iron bucket http://30004000.cn/
-
01-06
Processing technology of Jiangmen tin barrel manufacturer
Tin bucket is also quite common in life. With the development of the times, more and more people will choose plastic bucket, but there are still a group of people who are still using iron oil bucket. It is understood that the manufacturing process of iron barrel is very messy. Do you know anything about it? Follow Jiangmen iron bucket manufacturers to understand it! The tin barrel has good comprehensive properties, good strength, plasticity and welding properties, and is widely used. Before maki
-
01-06
How can a tin bucket reduce the speed of rusting?
Tin bucket is a tool used frequently in our life, which has a great and far-reaching impact on people. However, it is understood that many consumers will worry about the rust of the tin barrel. The tin barrel is frequently used in daily life and needs to be in contact with the air. It is impossible not to rust. How can the tin barrel not be easily embroidered? What are the better ways? It is a common and important method to cover the surface of tin barrel with protective layer to prevent rust. A
-
01-06
Maintenance method of Jiangmen iron barrel
Iron paint bucket is widely used in daily life. Therefore, the maintenance of iron paint bucket is also essential. The correct maintenance method can keep the appearance of iron paint bucket bright and prolong the service life of iron paint bucket. Then follow the Jiangmen foreign trade tin bucket to understand some maintenance methods of iron paint bucket. Before using the iron paint barrel, some oil, such as peanut oil and lard, can be applied on the iron paint barrel, so that the oil can cove
-
01-06
What are the principles of selecting tin barrel?
The coating packaging barrel is widely used in the world. With the careful design and manufacture of the coating packaging barrel manufacturer, the coating packaging barrel is convenient for loading and bearing large weight. It is suitable for the needs of medium-sized clients and has a wide range of applications. It can be used for the loading and transportation of liquid, semi liquid, powder, solid and other raw materials. What principles should be mastered when selecting the coating packaging